Daddaji Associates

Application

• For continuous service in pumping or turbid water upto 3000 ppm.
• Ideally suitable in circulating systems in industry, irrigation, sprinkler system, booster service, fire fighting, air-conditioning etc. (30°C to 100°C)
• Constructional Features :
• Pumps Are As Per Din 24256 And Iso 2858. The Design Is Of Back Pull Out Type. Large Variety Of Models Are Available To
• Operate At 1450 Rpm And 2900 Rpm.
• Casing :
• The Casing Has Axial Suction And Top Centre Line Delivery. Smooth Hydraulic Passages Ensure High Efficiency.
• Impeller :
• The Impellers Are Of Enclosed Type. Hydraulic Balancing Of Impellers Is Achieved Either By Back Vanes Or By Balancing Holes.
• The Impellers Are Statically And Dynamically Balanced. Reliable Fixing Of The Impeller On Shaft Is Achieved By Using Helicoil
• Insert Under Impeller Nut.
• Shaft :
• The Shaft Is Supported By Two Antifriction Bearings To Take Residual Axial Thrust And Prevent Axial Float Or Radial Run Out. It Is Fully
• Protected From The Liquid Handled By Means Of A Shaft Sleeve And Gaskets Between Impeller Nut, Impeller Hub And Shaft Sleeve.

Kirloskar GK(P) pumps are used for handling various types of chemical liquids. These pumps are manufactured to close tolerance and are of rigid construction. GK(P) pumps are mainly used in process industries. The complete range of GK(P) process pumps is covered by four driving units, thereby reducing inventory and achieving interchangeability.

Kirloskar End Section Process Pump KPD/KPDQF/KPDJ process pumps are used for handling various types of chemical liquids. These process pumps are manufactured to close tolerance and are of rigid construction. However, proper installation, operation and maintenance are equally important to ensure trouble free service. KPD/KPDQF/KPDJ process pumps are either gland packed or mechanically sealed. KPD pumps come with an enclosed impeller (with casing cover for heating/cooling arrangement.). KPD-QF pumps are equipped with a semi-open impeller while the KPD-J type pumps come with a jacketed delivery, casing and casing cover.

Kirloskar’s CE pumps are single stage pumps with a back-pull-out design, which enables to remove the rotating unit of pump for inspection and repairs without disturbing the pipe connections and motor by using spacer type coupling. The complete range of CE pumps is covered by four driving units thereby reducing inventory and achieving interchangeability of parts. These CE water pumps are either gland packed or mechanically sealed.

DBxe is dimensionally conforming to EN733/DIN24255. DBxe pump series is energy-efficient and complies with the requirement of Minimum Efficiency Index MEI ≥ 0.7 for water pumps as per EN 16480. These DBxe water pumps are either gland packed or mechanically sealed. The DBxe pumps are of a back-pull-out design which enables to the removal of the rotating unit of the pump for inspection and repairs without disturbing the pipe connections and motor by using spacer-type coupling.